First, start by soaking your frag mounts; then, cut using coral cutters around the base of the coral including some rock with it.
). Press as much water as possible off your sponges and then set outside to dry for a day or two. CLEANING AND DRYING CORAL Cleaning coral is a multi-step process. However, if your specimen is a soft coral, or perhaps a sponge of some sort, soaking in bleach will completely destroy it. Apply a small blob of R.E.E.F.-Fuze FCA to the attachment site on the disc, place the end of the coral or polyp into the FCA, then lightly… Then you’ll want to let the coral pieces dry out outside for about a day. When you clean coral, you’re actually cleaning off any leftover ‘skin’ that either still dying, or already dead. This will also whiten the hard parts. it stinks because the coral organisms have died and rotted.

1 decade ago. Soft corals grow so well, you probably need to frag them before they overtake another coral.

put it in the sun. Next, dry off the bottom of the coral and the frag plug; this allows the glue to hold. Anonymous. The rock gives you a solid base to glue the coral to the plug; otherwise, the coral would slime off the glue. First, the animals using the coral as a home must be removed. try microwaving it.

These tiny pieces of the skeleton, called sclerites, look like little crescent moons or even fingernail clippings (gross! 000. Login to reply the answersPost. Soft corals, by comparison, have very large, soft, fleshy polyps with tiny pieces of calcium carbonate skeleton included in their tissue. …the clipped end of branching stony corals or soft corals. All you have to do here is put the coral into a solution of bleach water (3 parts water, 1 part bleach) and let sit for a few hours.
Pat the end of the coral, polyp, or colony that is to be adhered to the disc dry with a clean towel. If it has a hard, stony core but is covered by a thin soft layer, these are the polyps and should be removed by soaking in 10% Chlorox for a few hours, followed by a fresh water rinse.